Authentication Mode - Psion Teklogix 7545 User Manual

Scan: Used to detect and list available wireless networks. You can highlight a network in the
list, and tap on Add New to activate the network.
There are two methods available when configuring a radio network—you can either scan for
an existing network or manually create a network. If you tap on the Scan button, a list of
networks detected by the radio is displayed. Highlighting one of the listed networks and
tapping on the Add New button creates a new profile that is completed based on the security
capabilities detected by the radio. You may need to add additional information, depending
on your network requirements.
If you tap on the Add New button rather than the Scan button, you can create a
network manually.
Important: The steps below describe how to manually create a network. Keep in mind
• Enter the SSID (Service Set Identifier) for your network.

2.8.2.1 Authentication Mode

Omnii supports several classes of authentication—Open, WEP, WPA/WPA2 (Personal PSK,
Enterprise, CCKM-WPA, CCKM-WPA2), and 802.1x with EAP. Tapping on the Auth. Mode
menu displays your authentication options.
that this is intended only as an example and may vary from your own
network requirements. If, for example, you are using a different type of secu-
rity for your network, the fields you complete may not match those described
here.
Psion Teklogix Omnii Hand-Held Computer User Manual
Chapter 2: Basic Operation
Wi-Fi Config: Configure Tab
21