Chapter 2 Install the Hardware
Installing 2.5" Drives
Install 2.5ʺ drive carriers vertically into the 24‐drive enclosure.
1 Make sure that the carrier is oriented so that the drive is on the left side and the handle
opens from the top.
2 Release the carrier handle by pressing the latch in the handle downwards.
3 Insert the carrier into the enclosure in the vertical position.
Figure 49. 2.5" Drive Carrier Module in Open Position
4 Gently slide the carrier all the way into the enclosure until it is stopped by the lever on
the bottom of the carrier.
Figure 50. Inserting a 2.5" Drive Carrier Module (1)
5 Rotate the handle firmly until the handle fully engages. You will hear a click as the latch
engages and holds the handle closed.
See Also
EN‐SASx6x12/24 Standard SAS Drives on page 29
EN‐SASx6x12/24 Drive Numbering on page 30
52
Storage Center SC8000 Controller Deployment Guide