Dell SC8000 Deployment Manual page 52

Chapter 2 Install the Hardware
2 Lift the IO card latch out of the slot.
Figure 38. Replacing the IO Card in Riser 2 or 3
1 IO card
2 IO card latch
3 Unpack the replacement IO card and prepare it for installation. For instructions, see the
documentation accompanying the IO card.
4 Hold the IO card by its edges and position the card so that the card‐edge connector
aligns with the IO card connector on the riser.
5 Insert the card‐edge connector firmly into the IO card connector until the card is fully
seated. Use the supports provided on the cooling shroud.
42
1
3 IO card connector
4 Riser
Caution: Make sure that the IO card is fully seated in the IO card connector. IO
cards that are not in full contact with the connector cause unpredictable failures
in Storage Center.
2
3
Storage Center SC8000 Controller Deployment Guide
4