Dell SC8000 Deployment Manual page 128

Chapter 4 Connect the Front End
3 Apply cable labels to both ends of each FC cable that connects a controller a front‐end
fabric or server.
a Prepare two labels by writing the controller number, slot, and port that the cable is
connected to.
b Near the connector, align the dotted line on the label with the edge of the cable and
affix it starting with the top edge of the label.
Figure 103. Align Cable Label
c Wrap the label around the cable until it fully encircles the cable. The bottom of each
pre‐made label is clear so that it does not obscure the text.
Figure 104. Wrap Cable Label
d Apply a matching label to the other end of the cable.
118 Storage Center SC8000 Controller Deployment Guide