Disconnecting the AC Power Cord
To disconnect the AC power cord from the W-7205 controller:
1. Lift the power cord retaining clip off the AC power cord.
2. Pull the AC power cord from the AC connector.
3. The W-7205 controller is now turned Off.
Installing an SFP/SFP+ Module
NOTE: Use standard ESD precautions when installing or removing an SFP/SFP+ module.
To install an SFP/SFP+ module into the W-7205 controller:
1. Slide the SFP/SFP+ module, top side facing upward, into a 10GBASE-X or 1000BASE-X ports on the controller
until a connection is made and an audible click is heard (see
Figure 14
Installing an SFP Module
Connecting an LC Fiber Optic Cable
To connect an LC fiber optic cable into an SFP-SX or SFP-LX module:
1. Clean the fiber optic cable connector before inserting it into the SFP/SFP+ module.
2. Insert the fiber optic cable into the SFP/SFP+ module. Ensure that the latch on the cable faces the top of the
SFP/SFP+ module (see
3. Slide the cable into place until a connection is made and an audible click is heard.
28 | Installation
Figure
15).
Figure
14).
Dell Networking W-7205 Controller | Installation Guide