Disconnecting the AC Power Cord
To disconnect the AC power cord from the W-7024 controller:
1. Lift the power cord retaining clip off the AC power cord.
2. Pull the AC power cord from the AC connector.
3. The W-7024 controller is now turned Off.
Installing an SFP/SFP+ Module
NOTE: Use standard ESD precautions when installing or removing an SFP/SFP+ module.
To install an SFP/SFP+ module into the W-7024 controller:
1. Slide the SFP/SFP+ module, top side facing upward, into a 10GBASE-X port until a connection is made and an
audible click is heard.
Figure 14:
Installing an SFP/SFP+
Removing an SFP/SFP+ Module
To remove an SFP/SFP+ module:
1. Open and release the latch on the SFP/SFP+ module.
2. Pull and remove the module from the port.
Connecting an LC Fiber Optic Cable
To connect an LC fiber optic cable into an SFP-SX or SFP-LX module:
1. Clean the fiber optic cable connector before inserting it into the SFP/SFP+ module.
2. Insert the fiber optic cable into the SFP/SFP+ module. Ensure that the latch on the cable faces the top of the
SFP/SFP+ module (see
3. Slide the cable into place until a connection is made and an audible click is heard.
25 | Installation
Figure
15).
Dell Networking W-7024 Controller | Installation Guide