Chapter 3 Connect the Back End
c Wrap the label around the cable until it fully encircles the cable. The bottom of each
pre‐made label is clear so that it does not obscure the text.
Figure 59. Wrap Cable Label
d Apply a matching label to the other end of the cable.
Connect SC200/SC220 Enclosures
This section shows common cabling between the SC8000 controller and SC200/220 SAS
enclosures. Locate the scenario that most closely matches the Storage Center you are
configuring and follow the instructions, modifying them as necessary.
An SC200/SC220 cabling chain can contain up to 168 SAS drives, using either type of
enclosure. The maximum number of any one type of enclosure is:
SC200: 14 enclosures
SC220: 7 enclosures
Each SAS IO card supports up to two chains of enclosures. All enclosures attached to the
same SAS IO card must be running at the same speed (all 6 Gb or 3 Gb).
SC200/220 SAS enclosure chains are cabled as follows.
Side A: Enclosures are connected from B port to A port, using the top EMMs.
Side B: Enclosures are connected from A port to B port, using the bottom EMMs.
60
Storage Center SC8000 Controller Deployment Guide