Ricoh MP 305 Plus Field Service Manual page 766

3. SP Mode Tables
1001 Bit Switch
009 Bit Switch 9
bit 0
bit 1
bit 2
bit 3
bit 4
1001 Bit Switch
009 Bit Switch 9
172
PDL Auto Detection timeout of jobs submitted via
USB or Parallel Port (IEEE 1284).
To be used if PDL auto-detection fails. A failure of PDL autodetection does not
necessarily mean that the job can not be printed. This bit switch tells the device
whether to time-out immediately (default) upon failure or to wait 10 seconds.
Not used
Job Cancel
Enable: All jobs will be cancelled after a jam occurs.
Note: If this bit switch is enabled, printing under the following conditions might result
in problems:
- Job submission via USB or parallel port
- Spool printing (WIM > Configuration > Device Settings > System)
Not used
Timing of the PJL Status ReadBack (JOB END) when
printing multiple collated copies.
This bit switch determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
Disable (=0 (default)):
JOB END is sent by the device to the client after the first copy has completed
printing. This causes the page counter to be incremented after the first copy and then
again at the end of the job.
Enable (=1):
JOB END is sent by the device to the client after the last copy has finished printing.
This causes the page counter to be incremented at the end of each job.
0 1
0:Disabled
1:Enabled
(Immediatel
(10 seconds)
y)
- -
0:Disabled
1:Enabled
(Not
(Cancelled)
cancelld)
- -
0:Disabled 1:Enabled
0 1