Ricoh MP 305 Plus Field Service Manual page 287

• Specified folder in [User Tools/Counter] - [Facsimile Features] - [Send Settings] -
[Backup File TX Setting].
• [Receiver] in [User Tools/Counter] - [Facsimile Features] - [Reception Settings] -
[Reception File Settings] - [Output Mode Switch Timer].
• [Store: Notify Destination] in [User Tools/Counter] - [Facsimile Features] - [Reception
Settings] - [Output Mode Switch Timer].
• All the destination information shown on the display.
• In the fax settings, address book data is stored with entry IDs, which the system internally
assigns to each data. The entry IDs may be changed due to re-assigning in backup/
restore operations.
4. Make sure that there is no transmission standby file. If any standby file exists, ask the customer
to delete it or complete the transmission.
8. Turn OFF the main power and unplug the power supply cord.
9. Press the main power switch again to discharge the residual charge.
10. Replace the NVRAM with a new one.
11. Turn ON the main power.
• SC673 appears at start-up, but this is normal behavior. This is because the controller and the
smart operation panel cannot communicate with each other due to changing the SP settings
for the operation panel.
1. Change the SP settings for the operation panel.
• SP5-748-101: (OpePanel Setting: Op Type Action Setting): Change bit 0 from "0" to "1".
• SP5-748-201: (OpePanel Setting: Cheetah Panel Connect Setting): Change the value from
"0" to "1".
12. Turn OFF then ON the main power with the SD card where the NVRAM data has been
uploaded in SD slot 2.
• SC992 appears at start-up, but this is normal behavior. This is because information written to
the NV-RAM and on the hard disk do not match due to replacement of the NV-RAM. Go to
Step 13.
13. Download the NVRAM data stored in the SD card to the brand-new NV-RAM using
SP5-825-001.
• The download will take a couple of minutes.
14. Turn OFF the main power and remove the SD card from SD slot 2.
Electrical Components, Other Items
279