Backside; Installation; Set Up And Operation; Control Modes - SHOWTEC COMPACT POWER LIGHTSET 4 RGBW Manual

Compact Power Lightset 4 RGBW

Backside

01) IEC Power Out (10a)
02) 5x 4-in-1 RGBW LEDs 4W (per spot)
03) Footswitch input
04) DMX signal connector (IN) 3-pin
05) DMX signal connector (OUT) 3-pin
06) Menu Buttons + LCD display
07) IEC Power In + Fuse: 5S1.5A / 250V
08) Ground/Earth connection
09) IEC Power Out (10a)

Installation

Remove all packing materials from the Compact Power Lightset 4 RGBW.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.

Control Modes

There are 6 modes:
Ordercode: 30277
 Sound-controlled
 Manual mode (Static)
 Auto Run
 Built-in Programs
 Master/Slave
 DMX-512 (4, 5, 6, 8, 10, 16, 19CH)
7
Fig. 01