Maintenance; Replacing A Fuse; Troubleshooting; No Light - SHOWTEC COMPACT POWER LIGHTSET 4 RGBW Manual

Compact Power Lightset 4 RGBW

Maintenance

The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01) All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The Showtec Compact Power Lightset 4 RGBW requires almost no maintenance. However, you should
keep the unit clean. Otherwise, the fixture's light -output will be significantly reduced. Disconnect the
mains power supply and then wipe the cover with a damp cloth. Wipe th e front glass panel clean with
glass cleaner and a soft cloth. Do not use alcohol or solvents. The front glass panel will require weekly
cleaning, as smoke-fluid tends to build up residues, reducing the light -output very quickly. Do not
immerse in liquid.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
01) Unplug the unit from electric power
02) Insert a flat-head screwdriver into a slot in the fuse cover.
the fuse will come out.
03) Remove the used fuse. If brown or unclear, it is burned out
04) Insert the replacement fuse into the holder where the old fuse was. Reinsert t he fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.

Troubleshooting

No Light

This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect four potential problem areas as the power supply, the LEDs, the fuse.
01) Power supply. Check that the unit is plugged into an appropriate power supply.
02) The LEDs. Return the
03) The fuse. Replace the fuse. See page 27 for replacing the fuse.
04) If all of the above appears to be in order, switch the unit on again.
05) If you are unable to determine the cause of the problem, do not open the
4 RGBW, as this may damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Ordercode: 30277
source.
Compact Power Lightset 4 RGBW
follow the directions below :
Gently pry up the fuse cover.
.
to your Showtec dealer.
27
Compact Power Lightset