One Compact Power Lightset 4 Rgbw (Sound-Control); One Compact Power Lightset 4 Rgbw (Manual Control); One Compact Power Lightset 4 Rgbw (Auto Run, Built-In Programs); Multiple Compact Power Lightsets 4 Rgbw (Master/Slave Control) - SHOWTEC COMPACT POWER LIGHTSET 4 RGBW Manual

Compact Power Lightset 4 RGBW

One Compact Power Lightset 4 RGBW (Sound-control)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the Compact Power Lighset is not connected by a DMX-cable, it functions as a stand-alone
device.
03) Turn on the music. If device is set to
music. Please see page 13 for more information about the Sound-controlled mode.

One Compact Power Lightset 4 RGBW (Manual control)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the Compact Power Lightset is not connected by a DMX-cable, it functions as a stand-alone
device.
03) If device is set to
04) Please see page 13 for more information about the Manual control mode.

One Compact Power Lightset 4 RGBW (Auto Run, Built-in programs)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the Compact Power Lightset is not connected by a DMX-cable, it functions as a stand-alone
device.
03) If device is set to
auto run mode. Please see pages 15-16 for more information about the built-in programs or auto run
mode.

Multiple Compact Power Lightsets 4 RGBW (Master/Slave control)

01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Use a 3-p XLR cable to connect the Compact Power Lightsets and other devices.
The pins:
04) Link the units as shown in Fig. 02, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. You can use the
same functions on the master device as described on pages 13-16 (Sound controlled, Manual
control, Auto run, Built-in Programs). This means you can set your desired operation mode on the
master device and all slave devices will react the same as the master device.
Multiple Compact Power Lightsets 4 RGBW (Master/Slave control)
Ordercode: 30277
(Audio), then the fixture will react to the beat of the
, then the fixture can be manually controlled.
or , then the fixture will play one of its built-in programs or show its
1. Earth
2. Signal (-)
3. Signal (+)
8
Fig. 02