Sun Oracle Sun SPARC Enterprise M3000 Product Notes page 33

Solaris OS Issues and Workarounds for All Supported Releases (2 of 3)
TABLE 3-2
CR ID Description
6660168 If a ubc.piowbeue-cpu error occurs on a
domain, the Solaris Fault Management
cpumem-diagnosis module might fail, causing
an interruption in FMA service. If this
happens, you will see output similar to the
following sample in the console log:
SUNW-MSG-ID: FMD-8000-2K, TYPE:
Defect, VER: 1, SEVERITY: Minor
EVENT-TIME: Fri Apr
2008
PLATFORM: SUNW,SPARC-Enterprise, CSN:
2020642002, HOSTNAME: <hostname>
SOURCE: fmd-self-diagnosis, REV: 1.0
EVENT-ID: 6b2e15d7-aa65-6bcc-bcb1-
cb03a7dd77e3
DESC: A Solaris Fault Manager
component has experienced an error
that required the module to be
disabled.
http://sun.com/msg/FMD-8000-2K for
more information.
AUTO-RESPONSE: The module has been
disabled.
module will be saved for manual
diagnosis.
IMPACT: Automated diagnosis and
response for subsequent events
associated with this module will not
occur.
REC-ACTION: Use fmdump -v -u <EVENT-
ID> to locate the module.
reset <module> to reset the module
6668237 After DIMMs are replaced the corresponding
DIMM faults are not cleared on the domain.
6723202 The raidctl command cannot be used to
create a hardware RAID using the onboard
SAS/LSI controller on the M3000 server.
The raidctl command can be used to view
disk/controller status, and can be used on any
PCI Host Bus Adapter (HBA) installed in the
system.
6745410 Boot program ignores the Kadb option which
causes the system not to boot.
4 21:41:57 PDT
Refer to
Events destined for the
Use fmadm
Workaround
If fmd service fails, issue the following
command on the domain to recover:
# svcadm clear fmd
Then restart cpumem-diagnosis:
# fmadm restart cpumem-diagnosis
Use the following commands:
# fmadm repair fmri|uuid
# fmadm rotate
No workaround is available.
Use kmdb instead of kadb.
Chapter 3 Information About Software 21