Sun Oracle Sun SPARC Enterprise M3000 Product Notes page 40

SPARC Enterprise M3000/M4000/M5000/
M8000/M9000 Servers XSCF User's Guide
The following changes were added to or not included in the August 2009 edition of
this document.
Documentation Updates
TABLE 3-7
Subject
Active Directory and
LDAP/SSL
Power Consumption
Monitoring Limitation
XSCF Unit/Firmware
Updates
28 Sun SPARC Enterprise M3000 Server Product Notes for XCP 1092 • May 2010
Change
Not yet added. See "Active Directory and LDAP/SSL" on page 2
Product Notes.
Added in the 1090 update of this document:
In the following cases, inaccurate power consumption values might be shown in
the MIB, in the showenvironment power command output, and on the XSCF
Web:
• During or for a short time after server power-on or power-off.
• During or for a short time after active replacement of a power supply unit.
To ensure the values are accurate, wait one minute, then check the values again.
Not yet changed in Chapter 8.1.10:
Replace steps 2 and 3 in these sections:
• Confirming That the XSCF Firmware is Updated When the XSCF Unit is
Replaced (in a System with a Single XSCF Unit or Both Replacement in a
System with Redundant XSCF Units
• Confirming That the XSCF Firmware is Updated When the MBU is Replaced
(in the M3000 Server)
The replacement steps are:
2. If the replacement unit and the replaced unit have different versions, a
message is displayed. In this case, the firmware is not updated automatically. The
operator must match the number of the firmware versions.
3. When you update, follow the procedure in "Updating XCP From External
Media" or "Updating XCP from the Network." After updating, confirm the
version.
of these