Chapter 2 Installation Guidelines
2.2.6
Jumper Settings and DIP Switch Settings
This section tells you how to set the jumpers and DIP switches to
configure your ADAM-5550KW Series Controller. It gives the system
default configuration and your options for each jumper and dip switch.
There is only one jumper (JP1) on the CPU card. The backplane has
one 8-pin DIP switch and six jumpers on it.
JP1 is for battery power ON/OFF setting
The following figure shows the location of the jumpers:
Figure 2-5: Jumper location on the CPU card
2-16 ADAM-5550KW Series User's Manual