Settings - Danfoss ECtemp 330 Installation Manual

ECtemp 330 (+5 to +45°C)
The screen of the heating cable must be connected
to the earth conductor of the power supply cable by
using a separate connector.
Note: Always install the floor sensor in a conduit in
the floor.
3. Turn on the power supply.
3

Settings

If a floor sensor is used, please be aware of the following:
• The floor temperature is measured where the sensor
is placed.
• The temperature of the bottom of a wooden floor can
be up to 10 degrees higher than the top.
Installation Guide
N
L
PE
7