Plugging In And Resetting The Deskphone Using The Dynamic Addressing Process; Phone Initialization - Avaya H.323 9608 Installation And Management Manual

Procedure
1. If already connected, remove the HAC cord from the underside of the phone.
2. With the phone facing up and resting flat on a hard surface, pry up a corner of the
3. Align the tabs on the 9641G Call Center faceplate with the slots on the outer edges
4. Ensure that the display bezel surrounding the screen is in proper position.
5. Plug the HAC cord back into the underside of the phone.
Plugging in and resetting the deskphone using the Dynamic
Addressing Process
Note:
Before you start this process you must have an extension number for the IP deskphone and
the Communication Manager security code (password) for that extension, unless you intend
to use the deskphone with unnamed registration. For more information, see
registration
server. You can run the plug in and reset process successfully using the following
description. If you see error messages, see
As the deskphone initializes, you see messages, some of which are part of DHCP process,
with a power on indication and dynamic feedback. These messages indicate that the phone is
active and not locked. You also receive useful information, about the status of the network, the
server, or the downloading operations, before the dial tone.

Phone initialization

This section description describes the software architecture on which the requirements are
based and provides an overview of how you can expect the phone to operate during startup
and software upgrades. This description is not a comprehensive description of all internal tasks
performed during startup.
Installing and maintaining Avaya IP Deskphone H.323 9608, 9608G, 9611G, 9621G, and 9641GJanuary 2014

Plugging in and resetting the deskphone using the Dynamic Addressing Process

standard faceplate. Use your fingers, a flat screwdriver, or other non-sharp device.
Continue prying around the edge of the standard faceplate until the faceplate is
released from the phone.
of the deskphone and push down to lock the tabs into the slots.
on page 34. Any reference to the HTTP server applies equally to an HTTPS
Chapter 5: Troubleshooting
About unnamed
on page 71.
27