WACKER Group LTC 4 Repair Manual page 35

LTC 4L
3.8.5
3.8.6
u
s
o
wc_tx000543gb.fm
After the mast is in the vertical position, check the operation of the
mast-mounted winch (q). Turn the telescope rotary switch (w) on the
control panel to the up position. Do not attempt to raise the mast if the
winch is damaged or not operating properly. Continue to hold switch in
the up position until mast is at the desired height. Release switch when
tower is fully extended.
CAUTION: Continuous running of the winch in excess of 4 minutes will
damage the winch motor.
CAUTION: Do not extend tower beyond red marking on mast!
Once the tower is at the desired height, rotate the mast to the desired
direction. To rotate, loosen rotation locking knob (s). Then using the
handle (u), rotate the mast until the lights face the desired direction
and then retighten rotation locking knob.
q
n
n
p
31
Operation
j
t
wc_gr002759