Replacing Fuel Tank - WACKER Group LTC 4 Repair Manual

Disassembly/Assembly Procedures

8.12 Replacing Fuel Tank

See Graphic: wc_gr002445
8.12.1 Shut down the engine and disconnect the battery.
8.12.2 Position the main mast in the vertical position.
8.12.3 Remove the screws (a) securing the mast cradle (b) and remove the
8.12.4 Remove the cable clamp (c) securing the tower power supply cable
8.12.5 Using a suitable rope or wire (e), secure the two doors in the open
8.12.6 Remove the four screws (f) securing the enclosure top and using an
8.12.7 Snip the wire ties (g).
8.12.8 Remove the bolts (h) securing the hold-down straps (i).
8.12.9 Disconnect the fuel intake (j) and return lines (k).
8.12.10 With the aid of a partner or appropriate hoist, lift the fuel tank from the
8.12.11 Position the fuel tank into the machine.
8.12.12 Slide new wire ties (g) underneath the hold-down straps (i) and secure
8.12.13 Reconnect the fuel intake (j) and return lines (k).
8.12.14 Using an appropriate hoist or crane, position the enclosure top onto the
8.12.15 Position the tower power supply cable (d) and secure it to the machine
8.12.16 Remove the rope or wire securing the two doors in the open position.
8.12.17 Secure the mast cradle (b) to the top enclosure using screws (a).
wc_tx000428gb.fm
Removal:
Note: It is not necessary to raise the tower.
mast cradle.
(d).
position.
appropriate hoist or crane, lift the enclosure top from the machine.
machine.
Reassembly:
the fuel tank to the machine with the hold-down straps using bolts (h).
machine. Secure the enclosure top to the machine with four screws (f).
using the cable clamp (c).
154
LTC Repair