Leveling Trailer; Adjusting Lights - WACKER Group LTC 4 Repair Manual

Operation
3.3

Leveling Trailer

See Graphic: wc_gr001420, wc_gr001423
WARNING
3.3.1
3.3.2
3.3.3
3.3.4
3.4

Adjusting Lights

See Graphic: wc_gr001423
wc_tx000543gb.fm
The trailer must be leveled and the outriggers extended before raising
the tower. The outriggers must remain extended while the tower is up.
Failure to level the trailer or extend the outriggers will severely reduce
the stability of the unit and could allow the tower to tip and fall.
Pull the locking pin on the tongue jack (a) and rotate the tongue jack
90° as shown. Make sure the tongue jack snaps into position.
Block or chock the trailer wheels (b). Crank the tongue jack down to
raise the trailer tongue off the vehicle.
Pull the outrigger lock pin (c) to release the outrigger. Pull both
outrigger extensions (d) out until you feel outrigger lock pin lock back
into place. Rotate jacks (e) down until they snap into position.
Rotate rear jack (f) down, as shown, making sure it snaps into place.
Extend the jack(s) on the highest side(s) of the trailer until they rest
firmly on the ground. Extend the remaining jacks until the trailer is
level.
Each light fixture can be aimed up, down, left or right. Position each
fixture by loosening toolless light adjusters (g) and aiming the light up
or down. DO NOT loosen the inside nut (x). Loosening this nut could
cause damage to the light fixture. Loosen the nut (h) to turn light
fixtures left or right. Tighten adjusters and nuts after positioning the
lights.
Always return the light fixtures to aim at the ground when mast is in the
cradle for towing.
24
LTC 4L