WACKER Group LTC 4 Repair Manual page 151

LTC Repair
WARNING
8.9.14 Attach the cable to the mid mast.
8.9.15 Hold the cable snug to upper side of the mid mast and insert it into the
8.9.16 Attach the five guides (g) using new self-tapping screws. Position the
WARNING
8.9.17 Route cable (yy) around main mast pulley (zz) and install the main
8.9.18 Slide the mid mast completely into the main mast.
8.9.19 Attach the cable to the winch.
8.9.20 See section Upper Mast for installing the upper mast.
wc_tx000428gb.fm
Disassembly/Assembly Procedures
Reassembly:
Replacement cables must be of the exact length of the original
equipment. Using shorter cables may cause severe personal injury.
main mast (a) 3/4 of the way, approximately 7 feet (2.3 m).
guides so that the self-tapping screws thread themselves into the
smaller side of the tapered hole in the guide.
Note: Limit reuse of the guides to one time.
The guides must be installed because they serve as safety stops.
Without them properly installed, the mid-mast section could be pulled
out of the main mast section, possibly causing severe bodily harm.
mast pulley.
147