Replacing Cable And Winch On Power Winch Models - WACKER Group LTC 4 Repair Manual

Disassembly/Assembly Procedures

8.11 Replacing Cable and Winch on Power Winch Models

See Graphic: wc_gr003159
8.11.1 Lower the tower.
8.11.2 Lower the mast assembly into the cradle.
8.11.3 Turn off the engine.
8.11.4 Remove the four screws (a) which secure the cover of the winch and
CAUTION
8.11.5 Using the appropriate switch (b) (or the auxiliary handle (c)), run the
8.11.6 Position the spool so that the retaining clamp (d) is accessible.
8.11.7 Loosen the screw which secures the clamp and the cable, and remove
8.11.8 To remove the winch, disconnect the motor wires (f). Then, remove the
8.11.9 To install the winch, position the winch on the machine and secure it
8.11.10 Thread the cable through the hole in the spool (e) so that when the
8.11.11 Secure the cable to the spool using the cable clamp (d) and screw. Be
8.11.12 Use the appropriate switch (b) or auxiliary handle (c) to wind up the
8.11.13 Reinstall the cover using four screws (a).
wc_tx000428gb.fm
Removal:
remove the cover.
Pinching hazard. Use extreme care when operating the winch with its
cover removed.
winch so that all remaining cable is unwound from the spool. Do not
run the winch for periods of longer than four minutes. Allow winch to
cool if necessary.
the cable from the spool.
screws (g) which secure the winch to the machine and remove the
winch.
Installation:
with screws (g). Then, connect the motor wires (f).
winch reels in the cable the cable winds around the top of the spool.
sure to secure the cable in both sides of the clamp.
cable.
152
LTC Repair