GE D60 Instruction Manual page 192

5.2 PRODUCT SETUP
Table 5–5: DIRECT INPUT AND OUTPUT DATA RATES
MODULE
74
7L
7M
7P
7T
7W
7V
2A
2B
2G
2H
76
5
77
75
7E
7F
7G
7Q
7R
7S
The G.703 modules are fixed at 64 kbps. The
NOTE
The
DIRECT I/O CHANNEL CROSSOVER
over messages from channel 1 to channel 2. This places all UR-series IEDs into one direct input and output network
regardless of the physical media of the two communication channels.
The following application examples illustrate the basic concepts for direct input and output configuration. Please refer to the
Inputs and outputs section in this chapter for information on configuring FlexLogic operands (flags, bits) to be exchanged.
5-70
CHANNEL SUPPORTED DATA RATES
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps, 128 kbps
Channel 2 64 kbps, 128 kbps
Channel 1 64 kbps, 128 kbps
Channel 2 64 kbps, 128 kbps
Channel 1 64 kbps, 128 kbps
Channel 2 64 kbps, 128 kbps
Channel 1 64 kbps, 128 kbps
Channel 1 64 kbps, 128 kbps
Channel 2 64 kbps, 128 kbps
Channel 1 64 kbps, 128 kbps
Channel 2 64 kbps, 128 kbps
Channel 1 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 128 kbps
Channel 1 128 kbps
Channel 1 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
Channel 1 64 kbps
Channel 1 64 kbps
Channel 2 64 kbps
setting applies to D60s with dual-channel communication cards and allows crossing
D60 Line Distance Protection System
setting is not applicable to these modules.
DIRECT I/O DATA RATE
5 SETTINGS
GE Multilin