Optional) Setting The Duration For Suppressing The Same Mld Messages; Checking The Configuration - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Multicast
4.7.5 (Optional) Setting the Duration for Suppressing the Same
MLD Messages
Context
To set the duration for suppressing the MLD Report messages with the same content, do as
follows on the S2700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mld-snooping suppression-time time-value
The duration for suppressing the same MLD Report messages is set.
----End

4.7.6 Checking the Configuration

Procedure
Step 1 Run the display mld-snooping [ vlan vlan-id ] command to check information about MLD
snooping in a VLAN.
----End
Example
If the preceding configurations are successful, the following information is displayed:
<Quidway> display mld-snooping vlan 10
MLD Snooping Vlan Information for VLAN 10
Issue 01 (2011-07-15)
NOTE
l By default, the duration for suppressing the same MLD Report messages is 10 seconds.
l The MLD snooping function is applicable to only the MLDv1 packets, but is invalid for the MLDv2
packets.
MLD Snooping is Enable
MLD Version is Set to default 1
MLD Query Interval is Set to default 125
MLD Max Response Interval is Set to default 10
MLD Robustness is Set to default 2
MLD Last Member Query Interval is Set to default 1
MLD Router Port Aging Interval is Set to 180s or holdtime in hello
MLD Filter Group-Policy is Set to default : Permit All
MLD Prompt Leave Disable
MLD Router Alert is Not Required
MLD Send Router Alert Enable
MLD Snooping Querier Disable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 MLD Snooping Configuration
65