Optional) Configuring The Mld Version; Checking The Configuration - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Multicast
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be an Ethernet interface, a GE interface or an Eth-Trunk interface.
Step 3 Run:
mld-snooping static-router-port vlan vlan-id
The interface is configured as a static router interface.
----End

4.3.6 (Optional) Configuring the MLD Version

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
mld-snooping version version
The version is configured for MLD protocol packets that can be processed by MLD snooping.
The version can be set to 1 or 2.
By default, the S2700 can process MLDv1 packets.
----End

4.3.7 Checking the Configuration

Procedure
Step 1 Run the display mld-snooping configuration command to check the configuration information
of MLD snooping.
Step 2 Run the display mld-snooping [ vlan vlan-id ] command to check the status of MLD snooping
in a VLAN.
Step 3 Run the display mld-snooping port-info [ vlan vlan-id [ group group-ipv6–address [ source-
address source-ipv6–address ] | verbose ] ] command to check information about member
interfaces of a multicast group and the router interface in a VLAN.
Issue 01 (2011-07-15)
NOTE
Before using the mld-snooping static-router-port vlan vlan-id command, ensure that the interface is
added to the VLAN specified by vlan-id; otherwise, the configuration fails.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 MLD Snooping Configuration
55