Configuring Prompt Leave Of Interfaces; Checking The Configuration - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Multicast
Pre-configuration Tasks
Before configuring the prompt leave function for interfaces in a VLAN, complete the following
tasks:
l
l
Data Preparation
To configure the prompt leave function for interfaces in a VLAN, you need the following data.
No.
1

4.5.2 Configuring Prompt Leave of Interfaces

Context
To configure the prompt leave function in a VLAN, do as follows on the S2700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
mld-snooping prompt-leave [ group-policy acl-number ]
Prompt leave is enabled for interfaces in the VLAN.
----End

4.5.3 Checking the Configuration

Procedure
Step 1 Run the display mld-snooping [ vlan vlan-id ] [ configuration ] command to check the
configuration of MLD snooping in a VLAN.
Issue 01 (2011-07-15)
4.3 Enabling MLD Snooping
Creating an ACL6
NOTE
By default, no interface is allowed to promptly leave a multicast group.
If group-policy acl-number is not specified in step 3, the S2700 deletes the forwarding entry of a member
interface immediately when receiving a Done message from the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 MLD Snooping Configuration
Data
ID of the VLAN where the prompt leave
function needs to be configured
58