Huawei Quidway S2700 Series Configuration Manual page 75

Quidway S2700 Series Ethernet Switches
Configuration Guide - Multicast
Figure 4-1 Networking diagram for configuring prompt leave of interfaces in a VLAN
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Create VLAN 3 on Switch A and add Eth 0/0/1, Eth 0/0/2, and Eth 0/0/3 to VLAN 3. The
configuration procedure is not provided here.
Step 2 Enable MLD snooping globally on Switch A.
[SwitchA] mld-snooping enable
Step 3 Enable prompt leave of interfaces in VLAN 3.
[SwitchA] vlan 3
[SwitchA-vlan3] mld-snooping prompt-leave
Step 4 Enable MLD snooping in VLAN 3.
[SwitchA-vlan3] mld-snooping enable
Issue 01 (2011-07-15)
DHCP server
IP/MPLS
core
Eth0/0/3
SwitchA
Eth0/0/1
VLAN 3
Host1 Host2 Host 3 Host 4 Host 5
Create VLAN 3 on Switch A and add Eth 0/0/1, Eth 0/0/2, and Eth 0/0/3 to VLAN 3.
Enable MLD snooping globally on Switch A.
Enable prompt leave of interfaces in VLAN 3 on Switch A.
Enable MLD snooping in VLAN 3 on Switch A.
ID of the VLAN where prompt leave is enabled: 3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
multicast source
Eth0/0/2
4 MLD Snooping Configuration
68