Terminal Configuration; Software Configuration - Avaya Nortel Communication Server 1000 Reference

Circuit card reference
Hide thumbs Also See for Nortel Communication Server 1000:
Table of Contents

Advertisement

Terminal configuration

For the MMI terminal to be able to communicate to the Lineside T1 card, the interface
characteristics must be configured to the following:
• Speed – 1200 or 2400 bps, depending on the setting of switch position 1 of Switch 1
• Character width – 8 bits
• Parity bit – none
• Stop bits – one
• Software handshake (XON/XOFF) – off

Software configuration

Although much of the architecture and many of the features of the Lineside T1 card differ from
the analog line card, the Lineside T1 card is designed to emulate an analog line card to the
CS 1000 software. Because of this, the Lineside T1 card software configuration is performed
the same as two adjacent analog line cards.
All 24 T1 channels carried by the Lineside T1 card are individually configured using the Analog
(500/2500-type) Telephone Administration program LD 10. Use
slot mapping
Software Input/Output Reference — Administration (NN43001-611) for LD 10 service change
instructions.
The Lineside T1 card circuitry routes 16 units (0-15) on the motherboard and eight (0-7) units
on the daughterboard to 24 T1 channels. The motherboard circuit card is located in the left
card slot, and the daughterboard circuit card is located in right card slot. For example, if the
Lineside T1 card is installed into card slots 0 and 1, the motherboard would reside in card slot
0 and the daughterboard would reside in card slot 1. To configure the terminal equipment
through the switch software, the T1 channel number must be cross-referenced to the
corresponding card unit number. This mapping is shown in
mapping
on page 171.
Table 78: DX-30 to T1 time slot mapping
Motherboard
Motherboard
Motherboard
Motherboard
Motherboard
Motherboard
Circuit Card Reference
on page 171 to determine the correct unit number and the technical document
Item
TN
T1 Channel Number
0
1
2
3
4
5
Installation and configuration
Table 78: DX-30 to T1 time
Table 78: DX-30 to T1 time slot
1
2
3
4
5
6
July 2011
171

Advertisement

Table of Contents
loading

Table of Contents