Remote Address - Elumen8 Kudos 60 Beam User Manual

Main Menu Sub Menu
Reset. M
Test. Chan
Test
Panel. Ctrl
Calibrate
Select. Pro
Program

Remote Address:

When this function is switched "ON" the user is able to define the required DMX address via a controller.
To remotely adjust the fixtures address, connect the fixture to a controller and power the fixture on.
Set the DMX value of "Channel 1" to "007" on the controller. Then set the DMX value of "Channel 2"
to "007" or "008" on the controller ("007" - allows the address to be set from 001-255, "008" - allows
the address to be set from 256-511). Now use "Channel 3" on the controller to set the required DMX
address. After setting "Channel 3" to the required DMX address wait for approximately 20 seconds for
the fixture to register the setting.
Example 1:
If the required DMX address is 076, "Channel 1" to "007" and "Channel 2" to "007", then set
"Channel 3" to a DMX value of "076".
Example 2:
If the required DMX address is 435, "Channel 1" to "007" and "Channel 2" to "008", then set
"Channel 3" to a DMX value of "179" (435–256=179).
Calibrate:
The calibrate funtion allows fine adjustments to be made to the motors for when a sensor has been
knocked slightly out of place. This function has been password protected to refrain from improper use.
The password to access this menu is "050" and must be entered each time the calibration menu needs
to be accessed.
www.prolight.co.uk
Options/Values (Default Settings in BOLD)
Pan&Tilt
Auto. Pro, PAN, PAN-Fine, TILT, TILT-Fine, Move. Sp,
Strobe, Dimmer, Red1, Green1, Blue1, White1,
Chase, Chase. Sp, Dim Modes, PANConRot,
TILTConRot, ColorMacro, DimmerFine, Chase Fade
Password Password = 050
Pro. Part 1 Program 1-Program 9 (Program 1)
Pro. Part 2 Program 1-Program 9 (Program 2)
Pro. Part 3 Program 1-Program 9 (Program 3)
Operating instructions
Description
Reset Pan/Tilt Motors
Test Functions
Fine Adjustments
Calibration of Motors
Program Select
Kudos 60 Beam User Manual
8