Xerox FaxCentre F116 Service Manual page 118

General Procedures/Information
into the telephone wall socket (the types of connector may vary depending on the coun-
try).
• If the machine is equipped with a LAN connection (depending on the model), plug one
end of the LAN cable (supplied by your network administrator) into socket (C) of the
machine and the other end into the local area network socket allocated to your
machine.
Powering up the machine
ATTENTION -REFER TO THE SAFETY REGULATIONS IN THE INTRODUCTION.
• Plug one end of the power cord (2) into the machine connector (E) and the other end
into the wall outlet (the types of connector may vary depending on the country).
• Set the on/off switch to the <I> position (On).
After a few seconds, as soon as the warm-up of the machine is finished, the date and the time are
displayed.
Connecting the PC
• Connect one end of the USB cable to the PC connector (D) located at the back of your
machine.
• Connect the other end of the USB cable to the USB port of your PC.
6-14 9/04 FaxCentre F116/F116L