Table of Contents
Advertisement
Furniture Mounting
For furniture mounting, do not attach the rubber feet. Furniture mount the switcher using
the optional MBU 125 under desk mounting kit (part #70-077-01) as follows:
1.
Remove feet from the bottom of the MTP SW6 if installed.
2.
Attach the furniture mounting brackets to the switcher with the four machine screws
supplied with the mounting kit (igure 5).
Figure 5.
3.
Hold the switcher with the attached brackets against the underside of the mounting
surface. Mark the location of the bracket's screw holes on the surface.
4.
Drill 3/32-inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep in the mounting
surface at the marked locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten each screw into the
mounting surface until just less than 1/4" of the screw protrudes.
6.
Align the mounting screws with the slots in the brackets and place the switcher
against the surface, with the screws through the bracket slots.
7.
Slide the switcher slightly forward or back to align it with the edge of the surface,
then tighten all four screws to secure the unit in place.
Attaching the furniture mounting brackets to an MTP SW6
MTP SW6 • Installation and Operation
8
Advertisement
Table of Contents
