Command/Response Table For Sis Commands - Extron electronics MTP SW6 User Manual

Command/Response Table for SIS Commands

Command ASCII Command
(host to unit)
Input selection
NOTE:
The switcher supports 1-, 2-, or 3-digit numeric entries (1!, 02&, or 003%). The switcher reports all selections with 1-digit
numbers.
NOTE:
The & select and % select commands for video can be used interchangeably.
X! X!
Select input video and
audio to output
Example: X! X! 1!
Select input video
only to output
Example 5&
X! X!
(see 2nd note above):
Select input video
only to output X! X!
Select input audio
only to output
Example: 2$
Auto level and peaking adjustment
NOTE:
The switcher must be running irmware version 1.02 or newer (issue the Q SIS command). Older irmware versions appear to
respond correctly, but do not adjust the level and peaking values correctly.
EX!AADJ}
Execute auto peaking
calibration
(with optional MTP signal
generator)
NOTE:
Before issuing the auto calibration command:
1. Disconnect the power and RJ-45 cables at the MTP transmitter connected to X!.
2. Connect the two cables to the optional MTP signal generator.
3. If the input cable is longer than 300 feet (90 m), set the MTP signal generator Pre-
Peak switch on (up when the RJ-45 connector on the signal generator is to the right
as shown). If the cable is shorter than 300 feet (90 m), set the switch down.
Manual video peaking adjustment EX!
Set a peaking value EX!
Increment peaking
EX!
Decrement peaking EX!
Show peaking
Manual video level adjustment
EX!
Set a level value EX!
Increment level EX!
Decrement level
EX!
Show level
X!
NOTE:
X@
= Input number
X#
= Threshold
X$
= Input peaking range
= Input level range
Response
(unit to host)
X!]
! All
]
X!]
All1
& Vid
]
Vid1
X!]
% Vid
X!]
$ Aud
]
Aud2
AadjX!*2] {start}
AllX!] {switch}
AadjX!*X@] {inished}
IpekX!*X#] {new value}
IlvlX!*X$] {new value}
X# } X! X#]
* IPEK } Ipek X! * X#]
+IPEK } Ipek X! * X#]
} X#]
-IPEK Ipek *
IPEK
X$ } X! X$]
} X! X$]
* ILVL Ilvl *
} X! X$]
+ILVL Ilvl *
-ILVL } Ilvl X$] *
ILVL
1-6
0 = outside threshold
00 - 65
000 - 255
Additional description
X!
Select input video and audio to be the output.
Select input 1 video and audio. X!
Select video (audio is broken away).
Select input 5 video.
X!
Select video (audio is broken away).
X!
Select audio (audio is broken away).
Select input 2 audio.
Switch input X! to the output and auto adjust the
peaking on input X!. The X@ value in the responses
reports whether the adjustment value was within or
outside of the threshold.
Pre-Peak
is on
X#
Set the peaking to .
Increase peaking setting 1 step.
Decrease peaking setting 1 step.
X$
Set the level to .
Increase level setting 1 step.
Decrease level setting 1 step.
1 = within threshold
MTP SW6 • Remote Control 23