Table of Contents
Advertisement
Furniture Mounting
Mount the 1U high, half-rack width unit under a desk or podium using the optional Extron
MBU 125 under desk mounting kit (part number 70-077-01) as follows:
1.
If rubber feet were previously installed on the bottom of the unit, remove them.
2.
Secure the mounting brackets to the unit with the machine screws provided (see
figure 21).
Figure 21.
3.
Hold the unit with the brackets attached against the underside of the table or other
furniture. Mark the location of the screw holes of the bracket on the mounting surface.
4.
Drill four pilot holes, each 3/32 inches (2 mm) in diameter by 1/4 inches deep (6.3 mm)
deep in the mounting surface at the marked screw locations.
5.
Insert provided #8 wood screws into the four pilot holes. Tighten each screw into the
mounting surface until just less than 1/4 inches (6.3 mm) of the screw head protrudes.
6.
Align the mounting screws with the slots in the brackets and place the unit against the
surface, with the screws through the bracket slots.
7.
Slide the unit slightly in or out, then tighten all four screws to secure the unit in place
(see figure 3).
Under-desk Mounting the Unit
Extron FOX SW8 • Reference Information
26
Advertisement
Table of Contents
