Furniture Mounting - Extron electronics SW2 USB User Manual

Diagrams
VersaTools Rack Shelf
1/2 Rack Width Front
False Faceplate
Use 2 mounting holes on
opposite corners.
Figure 17.
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 18.

Furniture Mounting

To mount the SW USB switcher under a desk, table, or podium, use the optional MBU 123
Mini Under-Desk Mounting Kit (part number 70-212-01), as follows:
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2.
Remove the two screws from one side of the SW USB. Retain the screws for possible
later reassembly.
3.
Attach the brackets to the sides of the unit, using the provided machine screws.
4.
Hold the unit with the attached brackets against the underside of the table or other
furniture. On the mounting surface, mark the location of the screw holes in the bracket.
5.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
HalfRackVersaToolsShelf
Mounting an SW USB Switcher on a 3.5-inch Deep Rack Shelf
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
Mounting an SW USB Switcher on a Standard 9.5-inch Deep Rack Shelf
(2) 4-40 x 3/16"
Screws
(2) 4-40 x 3/16"
Screws
SW USB Series • Reference Information 31 31 31