Replacing The I/O Cooling Module; Installing And Removing Hard Drives; Figure 22. Replacing An I/O Cooling Module - Intel MFSYS25 User Manual

Replacing the I/O Cooling Module

1. Review the safety and ESD information at the beginning of this manual and in the
appendices.
2. Press the I/O cooling module retention latch to release the I/O cooling module from
the module bay (see letter "A" in the following figure). Slide the I/O cooling module
out of the module bay (see letter "B"). Slide the replacement I/O cooling module into
the vacant module bay (see letter "C") until the retention latch engages.
Warning: Replace the cooling module with another cooling module within two minutes.
B

Installing and Removing Hard Drives

The Intel
modules by way of an on-board storage bay combined with a storage management
module. The on-board storage bay supports the installation of up to 14 hot-swap 2.5-inch
SAS hard drives that are configured through the integrated server control software. Refer
to "Configuring the Server Chassis" on page 41
Caution: Only hard drives validated for use in the Intel
be installed. You may damage the Intel
Intel® Modular Server System MFSYS25 User Guide
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A

Figure 22. Replacing an I/O Cooling Module

®
Modular Server System MFSYS25 provides storage for installed compute
for more information.
®
Modular Server System MFSYS25 should
®
Modular Server System MFSYS25 if you install a
1
2
3
4
5
6
7
8
9
10
11
12
13
14
C
AF002417
31