Table 4-4 Default Conditions - Keithley 7002 Instruction Manual

Front Panel Operation
1. To power-on to the setup conditions stored at the dis-
played memory location, press ENTER. The instrument
will return to the SETUP MENU.
2. To power-on to setup conditions stored at a different
memory location, key in the memory location (0 to 9)
and press ENTER. The instrument will return to the
SETUP MENU.
RESET — Use this menu item to reset the instrument to the
RESET default setup conditions (see Table 4-4). To select
RESET, place the cursor on RESET and press ENTER. The
following message will be displayed:
RESETTING INSTRUMENT
Table 4-4
Default conditions
Item
Display mode
Channel status
Channel list
Scan list
GPIB address
Digital I/O output level
Language
Status messages
# of poles
Card pair
Delay
Channel spacing
Number of channels
Channel trigger control
Scan spacing
Number of scans
Scan trigger control
Arm spacing
Arm count
Arm trigger control
Single channel
Restricted channels
Interlock
Break Before Make
LED Graticule
Note: "No change" indicates that the currently set conditions are not affected.
4-32
Press ENTER to confirm or EXIT to abort. Pressing ENTER
will display the following message:
RESET COMPLETE
Press ENTER to return to the SETUP MENU.
When finished with SAVE SETUP, use
EXIT to back out of the menu structure.
Factory default RESET
Relay status No change
All open All open
Cleared No change
No change No change
No change No change
High High
No change No change
Off Off
No change No change
Off Off
0 sec 0 sec
Manual (STEP key) Manual (STEP key)
Scan list length Scan list length
Source Source
Immediate Immediate
Infinite Infinite
Acceptor Acceptor
Immediate Immediate
1 1
Acceptor Acceptor
Off Off
No change No change
No change No change
On On
On On
NOTE