Installation - NEC Express5800/T120d User Manual
Express server express5800 series
Hide thumbs
Also See for Express5800/T120d:
- Hardware specificftion (2 pages) ,
- Configuration manual (63 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.12.3 Installation
Install a riser card to a PCI board in the following procedure.
1.
Refer to steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Confirm the installation position with the reference to the table on Chapter 2 (1.12.2 Supported boards
and available slots).
3.
Push the retention to unlock the PCI card from PCI slot. Bring down the lever toward rear of the server,
and remove the blank cover.
Important
When installing a PCI board, make sure the connector of the board fits the
connector of the slot.
If the battery for RAID controller is installed, refer to Chapter 2 (1.11 Battery for
Note
RAID Controller).
Note
Keep the removed blank cover for future use.
Express5800/T120d User's Guide
1. Installing Internal Optional Devices
83
Advertisement
Table of Contents
