Removal - NEC Express5800/T120d User Manual

Chapter 2 Preparations

1.22.2 Removal

Remove a hard disk drive in the following procedure.
If you transfer or dispose of the removed hard disk drive, you must erase the stored data completely. Refer to
Chapter 1 (1. Transfer, Movement, and Disposal) in "Maintenance Guide" to erase data.
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
1.
2. Push the lever to unlock and open the
handle.
3. Hold the drive carrier firmly and pull out the
hard disk drive.
4. If you intend to use the server while the hard
disk drive is removed, fill the open slot with
a dummy tray.
Important
NEC assumes no liability for data leakage should the product be
transferred to a third party without erasing the data.
Note
If you have to remove a disk due to a hard disk drive failure, check the slot with its
DISK LED lit in amber.
Note
Do not pull the slot out from the handle. Doing so may damage the handle.
Express5800/T120d User's Guide
1. Installing Internal Optional Devices
DISK LED
125