Removal - NEC Express5800/T120d User Manual
Express server express5800 series
Hide thumbs
Also See for Express5800/T120d:
- Hardware specificftion (2 pages) ,
- Configuration manual (63 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.10.6
Removal
Remove a DIMM in the following procedure.
1.
Refer to steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Rotate both levers of the DIMM socket
outward. The socket is unlocked and DIMM
can be removed.
3.
Pull out the DIMM straight.
4.
Confirm that no error messages are displayed on POST. If any error message is displayed, refer to
Chapter 3 (1. POST Error Message) in "Maintenance Guide".
5.
Run BIOS Setup Utility, select Memory Configuration from the Advanced menu, and then specify Yes
for Memory Retest. After that, select Save Changes and Exit to reboot.
6.
Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information)) in
"Installation Guide (Windows)".
For other OS, follow the manual of the OS.
68
When removing a defective DIMM, check error messages displayed at POST or
Note
NEC ESMPRO and check the DIMM socket where the defective DIMM is
installed.
At least one DIMM needs to be installed for the server to operate.
Express5800/T120d User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
