Turning On The Server - NEC Express5800/T120d User Manual
Express server express5800 series
Hide thumbs
Also See for Express5800/T120d:
- Hardware specificftion (2 pages) ,
- Configuration manual (63 pages)
Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Pressing the POWER switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1.
Turn on the peripheral devices that connect to the display monitor and the server.
2.
Press the POWER switch at the front of the server.
The POWER LED is turned on green and after a while, the NEC logo appears on the display.
While the NEC logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the
hardware. For details, refer to Chapter 3 (1.1.1 POST sequence).
• Do not power on the server before amber POWER LED is unlit.
Tips
• Wait for at least 30 seconds before turning on the server after turning off the
server.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/T120d User's Guide
1. Turning on the Server
POWER switch
POWER LED
137
Advertisement
Table of Contents
