Installation - NEC Express5800/T120d User Manual

Chapter 2 Preparations

1.10.5 Installation

Install a DIMM by using the following procedure.
1. Refer to steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Open levers at both ends of the target DIMM slot.
3. Rotate both levers outward and push the
DIMM straight into the socket.
When a DIMM is inserted into the socket,
the lever automatically closes.
4. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
5. Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
6. Run BIOS Setup Utility and select Memory Configuration and then Memory Information from the
Advanced menu. Make sure the capacity of added DIMM is displayed properly.
Refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
7. Select Memory Configuration from the Advanced menu, and then specify Yes for Memory Retest.
After that, select Save Changes and Exit to reboot.
8. Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information)) in
"Installation Guide (Windows)".
For other OS, follow the manual of the OS.
• Make sure the orientation of the DIMM. The DIMM has a notch, preventing
Important
being wrongly inserted.
• Do not apply too much pressure when you push a DIMM into the socket.
Doing so can damage the socket or terminal part.
Express5800/T120d User's Guide
1. Installing Internal Optional Devices
Notch
Key
67