Warranty And After-Service - Fuji Electric FD5000 series Instruction Manual

Instruction Manual for FD5000 Series
log Output
Output type Load resistance
0 to 1V 10k1 or more
0 to 10V 10k1 or more
10k1 or more
1 to 5V
4 to 20mA 5501 or less
Note : The ripple ratings for the 4-20 mA output are when the load resistance
of 250 1 and the output current of 20 mA are applied.
Conversion system : PWM conversion
Resoluton : Equivalent to 13 bits
Scaling : Digital scaling
Response speed : About 0.5 second
8.3.3 Communicating Function
RS-232C
Synchronization system
Communication system Full duplex
Communication rate 38400bps/19200bps/9600bps/4800bps/2400bps
Start bit
Data length
Error detection
Stop bit
Character code
Communication control
procedure
Signal name used TXD,RXD,SG
Number of connectable
units
Line length
Delimiter
Accuracy Ripple
± 50mVp-p
± (0.5% of FS)
± 25mVp-p
RS-485
Start and stop synchronization
Two-wire half duplex
(Polling selecting system)
1bit
7 bits/8 bits
Even parity/odd parity/non-parity
BCC (block, check, and character)
check sum
1 bit/2 bits
ASCII code
No procedure
Non-inversion (+)
and inversion (-)
1 1 Up to 31 meters
15m Up to 500 m (total)
CR+LF/CR
8.4 External Dimensions
9

Warranty and After-service

.
9.1 Warranty
The warranty period shall be one year from the date of delivery. Any failure
that arises during this period and the cause thereof is judged to be obviously
attributable to Fuji Electric Instruments Co., Ltd. shall be remedied at no
cost.
9.2 After-service
This product is manufactured, tested, inspected, and then shipped under
stringent quality control. Should the product fail, however, contact (or
send the product to) your vendor or Fji Electric Instruments directly. (It
is advisable that you send a memo describing the failure in as much detail
as possible along with the product returned.)
11/12