S
S
S
UPER
TORAGE
2
1
0
Control Panel
Note: numbers above indicate the logical drive locations (drive map).
Power Supplies
2x Optional Hot-Swap 2.5" Drive Bays
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airflow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
6-3
Accessing the Inside of the Chassis
Some maintenance will require accessing the inside of the server.
Removing the Chassis Cover (Figure 6-2)
1. Remove the two screws from the sides of the chassis cover.
2. Press both release tabs at the same time to unlock the cover.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover off the chassis.
YSTEM 6028R-E1CR12T User's Manual
Figure 6-1. Front and Rear Chassis Views
5
4
3
SATA Drives (12)
I/O Ports
8
7
6
6 Low-profile PCI Slots
6-2
11
10
9