Supermicro 6028R-E1CR12T User Manual page 68

S S S
UPER TORAGE
VGA Enable/Disable
JPG1 allows you to enable or disable
the onboard VGA port. The default
position is on pins 1 and 2 to enable
VGA. See the table on the right for
jumper settings.
Watch Dog Enable/Disable
JWD1 controls the Watch Dog
function. Watch Dog is a system
monitor that can reboot the system
when a software application "hangs".
Pins 1-2 will cause WD to reset the
system if an application hangs. Pins
2-3 will generate a non-maskable
interrupt signal for the application that
has hung. See the table on the right
for jumper settings. Watch Dog must
also be enabled in BIOS.
BMC Enable
Jumper JPB1 allows you to enable the
embedded the onboard Baseboard
Management controller (BMC) to
provide IPMI 2.0/KVM support on the
serverboard. The default setting is
enabled. See the table on the right for
jumper settings.
Manufacturer Mode Select
Close pin 2 and pin 3 of jumper
JPME2 to bypass SPI flash security
and force the system to operate in
the Manufacturer (ME) mode, allowing
the user to flash the system firmware
from a host server for system setting
modifications. See the table on the
right for jumper settings.
YSTEM 6028R-E1CR12T User's Manual
VGA Enable/Disable
Jumper Settings
Jumper Setting Defn
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
ME Mode Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-22
Enabled
Disabled
Watch Dog
Defn
Reset
NMI
Disabled
BMC Enable
Definition
BMC Enable
Normal
Definition
Normal
Manufacture Mode