Onboard Indicators - Supermicro 6028R-E1CR12T User Manual

I C Bus to PCI-Exp. Slots
2
Use jumpers JI
nect the System Management Bus
(I C) to PCI-Express slots to improve
2
PCI performance. These two jumpers
are to be set at the same time. The
default setting is disabled. See the
table on the right for jumper settings.
SAS Enable/Disable
Jumper JPS1 allows the user to en-
able the onboard SAS ports. The
default setting is enabled. See the
table on the right for jumper settings.
5-9

Onboard Indicators

LAN Port LEDs
Two LAN ports are located on the rear
I/O panel. Each Ethernet LAN port has
two LEDs. The green LED indicates
activity, while the other Link LED may
be green, amber or off to indicate the
speed of the connections. See the
tables at right for more information.
Dedicated IPMI LAN LEDs
A dedicated IPMI LAN port is also
located on the rear I/O panel. The
amber LED on the right indicates
activity, and the green LED on the
left indicates the speed of the con-
nection. See the tables at right for
more information.
C1 and JI C2 to con-
2 2
Chapter 5: Advanced Serverboard Setup
I C for PCI-E Slots
2
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
SAS Enable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
LAN Port Activity
Color
Green
LAN Port Link LED (Right)
LED Color Definition
Off
Green
Amber
IPMI LAN Activity Indicator
Color Status
Amber Flashing
IPMI LAN Speed LED
LED Color
Green 100 Mbps
Amber 1 Gbps
5-23
Definition
Enabled
Disabled
Definition
Enabled
Disabled
LED State
Status Definition
Flashing Active
LED State
10 Mbps, 100 Mbps, or
No Connection
10 Gbps (X10DRH-CT)
1 Gbps
LED States
Definition
Active
Definition