Serverboard Features; Processors; Memory; Sas - Supermicro 6028R-E1CR12T User Manual

S S S
UPER TORAGE
1-2

Serverboard Features

The SuperStorageSystem 6028R-E1CR12T is built around the X10DRH-CT, a dual
processor serverboard based on the Intel C612 chipset. Below are the main features
of the X10DRH-CT. (See Figure 1-1 for a block diagram of the chipset).

Processors

The X10DRH-CT supports single or dual Intel® E5-2600 (v3) processors in Socket
R3, LGA 2011 type sockets. Please refer to our website for a complete listing of
supported processors (www.supermicro.com).

Memory

The X10DRH-CT has 16 DIMM slots that can support up to 1 TB of Load Reduced
(LRDIMM) ECC registered memory or up to 512 GB of registered (RDIMM) DDR4-
2133/1866/1600 memory. Please refer to Chapter 5 for details on installing memory.

SAS

An LSI 3108 SAS controller is included on the serverboard to support up to eight
SAS 3.0 ports with RAID 0, 1, 5, 6, 10, 50 and 60.

SATA

A SATA controller is integrated into the C612 chipset to provide ten SATA 3.0 ports,
with RAID 0, 1, 5 and 10.
Note: The SATA drives are hot-swappable units. You must have your RAID set up
to enable the hot-swap capability of the SATA drives. Documentation on RAID setup
guidelines can be found on our website.

PCI-E Expansion Slots

The X10DRH-CT has six PCI-E 3.0 x8 slots and one PCI-E 3.0 x16 slot. Note
that the PCI slots are controlled by the CPUs so only three slots (Slot1-Slot3 ) are
available if both CPUs are not installed on the board at the same time. (CPU1:
Slot1-Slot3, CPU2: Slot4-Slot7.) See Figure 1-1 and the serverboard layout in
Chapter 5 for details.

Rear I/O Ports

YSTEM 6028R-E1CR12T User's Manual
1-2