Introduction - AEMC 670 User Manual

● Read the user manual before operating and
follow all safety information.
● Only use the meter as specified in this user
manual.
● Never use this meter on a circuit with volt-
ages greater than 600Vrms @ 50/60Hz,
CAT IV or 1000V, CAT III.
● Never measure current while the test leads
are connected to the input jacks.
● Do not operate the meter if the body or test
leads look damaged.
● Check the rotary range switch and make
sure it is at the correct position before each
measurement.
● Do not perform resistance and continuity
test on a live circuit.
● Use extreme caution when measuring live
systems with voltages greater than 60V
30V
● Use extreme care when working around bus
bars and bare conductors.
● Do not use the meter in over range/overload
conditions (
● For accurate readings, change the battery
when the
Clamp-on Meter Models 670 and 675
CHAPTER 1

INTRODUCTION

Warning
.
AC
).
symbol appears.
or
DC
3