Dc Current Measurement (675 Only) - AEMC 670 User Manual

4.3

DC Current Measurement (675 only)

NOTE: Remove the test leads before measuring current
if DC voltage is not going to be measured at the same
time
• Turn the rotary range switch to the
• If needed, the display may be "zeroed". Press and
hold down the HOLD button for approx 2s.
• Clamp the jaws around the conductor to be measured.
• The main display is A
The DISPLAY button is inoperative.
• If reading is unstable and is hard to read, push the
HOLD button and read the measurement.
WARNING: If overload "
unclamp the meter immediately .
Clamp-on Meter Models 670 and 675
, the secondary display is V
DC
" is displayed,
range.
DC
.
17