Daikin F-Series Service Manual page 142

SiBE12-712C
To start COMFORT AIRFLOW operation
3. Press "COMFORT AIRFLOW button".
• The flap position will change, preventing air from blowing directly on the occupants of the room.
• "
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
To cancel COMFORT AIRFLOW operation
4. Press "COMFORT AIRFLOW button" again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• "
Notes on COMFORT AIRFLOW operation
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time.
Priority is given to POWERFUL operation.
Notes on flaps and louvers angles
• When " SWING button " is selected, the flaps
swinging range depends on the operation mode.
(See the figure.)
ATTENTION
• Always use a remote controller to adjust the flaps
angle. If you attempt to move it forcibly with hand
when it is swinging, the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the
air outlet, a fan is rotating at a high speed.
Operation Manual
" is displayed on the LCD.
" disappears from the LCD.
In DRY mode or COOL mode
When stop operation
10°
Upper limit
50°
Lower limit
In HEAT mode
When stop operation
30°
Upper limit
65°
Lower limit
In FAN mode
When stop operation
5°
Upper limit
70°
Lower limit
Instruction
131