Daikin F-Series Service Manual page 125

Instruction
Outdoor Unit
Indoor Unit
1. Air filter
2. Air purifying filter with
photocatalytic deodorizing function:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. INTELLIGENT EYE sensor:
• It detects the movements of people and auto-
matically switches between normal operation
and energy saving operation.
8. Display
9. Air outlet
10. Flaps (horizontal blades)
11. Louvers (vertical blades):
• The louvers are inside of the air outlet.
Outdoor Unit
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
Appearance of the outdoor unit may differ from some models.
114
12. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Temperature
Mode
FTKS COOL
FTXS AUTO
• This switch is useful when the remote controller
is missing.
13. Operation lamp (green)
14. TIMER lamp (yellow)
15. HOME LEAVE lamp (red)
16. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
21. Earth terminal:
• It is inside of this cover.
22. Outside air temperature sensor: (Back side)
• It senses the ambient temperature around the
unit.
SiBE12-712C
Airflow
setting rate
22°C AUTO
25°C AUTO
Operation Manual